Posted by Mark (204.50.168.60) on July 10, 2003 at 09:30:29:
In Reply to: Re: Can't arm system posted by SafeWatchService.com on July 09, 2003 at 22:46:48:
Guys, thanks for the help, I did not put any resistors in and gorgot to change section 013 to reflect that. I changed it last night and all is well. Thanks for the support!!
: Are you sure it's the motions that are showing open? If they are setup correctly (as a type 05 - Home/Away Zone), then you'll be able to arm the system even if they are open.
: The only other possibility is that you have EOL enabled and don't have the resistors on the zones.
: Good luck!
: : Hello, I have a PC5010 with a LCD5500 keypad. I have only two motion connectors hooked up right now with no door contects. I try to arm the system and it always fails stating to close the zones first. I each motion wired up to a seperate zone. Any suggestions why the zones say they are open (btw motion detectors are not picking up any movement when the system is being armed.....so they should be in a closed state
: : Thanks
: : M