Brinks Devices installed in ITI Concord Panel

[ Follow Ups ] [ Post Followup ] [ AlarmsBC Messages Board ]

Posted by Sal (128.107.253.40) on March 25, 2004 at 15:59:35:

I just purchased a ITI Concord system /keypad and am trying to install the existing components (door, motion and smoke) that were part on my Brinks BHS-2000F.

1) I am not sure where to connect the siren that came with the Brinks. The ITI manual has an option to connect a 8-ohm speaker in addition to 2 outputs. Output 2 indcates that this is typically for interior speakers. The wires on the brinks went to a +12V power and a COMM (ground). The 2 ITI Speaker connections at the panel do not indicate + or - charged. Anyone do a similar conversion and have any advise as to where to connect this siren?

2) The ITI manual notes that devices should have a 2k Ohm EOL Resistor inline per zone. Does the Brinks also require this so I would not need any additional or should I assume that there are no resisters inline and add one at the panel?

3) Any advise on connecting the Brinks Smoke/Heat 4 wire detector to the ITI? The manual only references ITI products.

4) Is there any danger in trial and error on the device connection wiring or by doing so could I damage the panel or device?

5) Any other general advice is appreciated.

Thanks in advance.

Follow Ups:

Post a Followup

Name:
E-Mail:

Subject:

Comments:
: I just purchased a ITI Concord system /keypad and am trying to install the existing components (door, motion and smoke) that were part on my Brinks BHS-2000F. : 1) I am not sure where to connect the siren that came with the Brinks. The ITI manual has an option to connect a 8-ohm speaker in addition to 2 outputs. Output 2 indcates that this is typically for interior speakers. The wires on the brinks went to a +12V power and a COMM (ground). The 2 ITI Speaker connections at the panel do not indicate + or - charged. Anyone do a similar conversion and have any advise as to where to connect this siren? : 2) The ITI manual notes that devices should have a 2k Ohm EOL Resistor inline per zone. Does the Brinks also require this so I would not need any additional or should I assume that there are no resisters inline and add one at the panel? : 3) Any advise on connecting the Brinks Smoke/Heat 4 wire detector to the ITI? The manual only references ITI products. : 4) Is there any danger in trial and error on the device connection wiring or by doing so could I damage the panel or device? : 5) Any other general advice is appreciated. : : Thanks in advance.

Optional Link URL:
Link Title:
Optional Image URL:

[ Follow Ups ] [ Post Followup ] [ AlarmsBC Messages Board ]