Posted by SafeWatchService.com (24.197.146.10) on March 28, 2004 at 20:50:45:
In Reply to: ademco vista 10 posted by JK on March 26, 2004 at 15:38:00:
: I have an ademco Vista 10 Alarm and with help from your posts and answers (Thanks) I've been able to access my system "New installer code". 1.My system arms and disarms ok, but when I open a door to exit (during the exit/delay period) the alarm sounds. 2.Also when the system is in ready state if I open one particular door it triggers an alarm and keypad reads check 03 and then I need to disarm it. Thinking sensor or programming. Any help/direction would be appreciated.
: Thanks, JK
It sounds like the door you are opening is not a delay door. You may need to reprogram that zone.
Also, I think your Zone 03's EOL is either missing or installed improperly. Make sure it's in series with the zone loop and the proper size.
Good luck!
Brandon